Autodesk Revit for MEP DisciplinesTest your basic knowledge on Autodesk Revit for MEP disciplines with BIMNCADAutodesk Revit for MEPStep 1 of 250%In Autodesk Revit, you can add and remove Air Terminals from an existing Air System.TrueFalseWhich of the following tools is used to inspect the estimated Air Flow in modeled Ducts?Measure FlowFlow CalculatorSystem InspectorDuct/Pipe SizingMechanical Equipment(s) are added to control the flow of air from Duct to Air Terminals?FalseTrueWhile assigning an electrical panel to a power system in Autodesk Revit, sometimes Panel is not available from the drop-down list. What is the probable cause of this in Revit?Four Phase distribution system is requiredNone of the aboveModeled electric panel is not compatibleDistribution System is not set for PanelThe recommended comfortable velocity of air coming out through an Air Terminal is 10 meters/second.TrueFalseFor Electrical systems, you can automatically add wires from Lighting Fixtures to Lighting Switches.TrueFalseWhile modeling Plumbing systems, it is advisable to use 90 degree pipe fittings.FalseTrueIn Panel Schedules, you cannot interchange systems between different R Y B circuits.TrueFalseName* First Last Phone*Email* NameThis field is for validation purposes and should be left unchanged.
