Autodesk Revit for MEP DisciplinesTest your basic knowledge on Autodesk Revit for MEP disciplines with BIMNCADAutodesk Revit for MEPStep 1 of 250%In Autodesk Revit, you can add and remove Air Terminals from an existing Air System.TrueFalseWhile assigning an electrical panel to a power system in Autodesk Revit, sometimes Panel is not available from the drop-down list. What is the probable cause of this in Revit?None of the aboveDistribution System is not set for PanelFour Phase distribution system is requiredModeled electric panel is not compatibleFor Electrical systems, you can automatically add wires from Lighting Fixtures to Lighting Switches.FalseTrueWhile modeling Plumbing systems, it is advisable to use 90 degree pipe fittings.FalseTrueMechanical Equipment(s) are added to control the flow of air from Duct to Air Terminals?TrueFalseThe recommended comfortable velocity of air coming out through an Air Terminal is 10 meters/second.TrueFalseWhich of the following tools is used to inspect the estimated Air Flow in modeled Ducts?Duct/Pipe SizingSystem InspectorMeasure FlowFlow CalculatorIn Panel Schedules, you cannot interchange systems between different R Y B circuits.TrueFalseName* First Last Phone*Email* CommentsThis field is for validation purposes and should be left unchanged.
